tips on building a high rpm motor

[IH8DSM]

figured id update this i havent forgot about a nice na build

Originally Posted by IH8DSM

-s4 turbo motor ran as a na bridge ported(used housings/irons)
-s5 rotors
-race rotor bearings -
-rx8 eshaft
-rx8 front and rear stationary gears
-cryo treated 2mm apex seals atkins
-cryo treated side seals atkins
-solid corner seals
-new apex seal springs, corner seal springs and side seal springs
-aluminum light weight flywheel
-rotating assembly balanced

figured id add to this
- turblown studs (zachs gonna yell at me for this one)
- oil pan baffle
- shimmed front cover/ shimmed rear opr
- turbo2 oil pump
- studded oil pan w/brace
- some kind of transmission blanket/ scatter shield

figure thats enough for now a lot of parts have been ordered already so hopefully i can start porting cleaning and finish gathering parts to where i can build me a motor after christmas.