Rice Racing M&W CDI COP Set-up

[Monkman33]

But the single screw mounting point doesn't look like it would prevent the coils from vibrating. I would rather the cop link would not bear any weight. Since spark plugs dont really like to hold mich weight either.

[RICE RACING]

Originally Posted by Monkman33

But the single screw mounting point doesn't look like it would prevent the coils from vibrating. I would rather the cop link would not bear any weight. Since spark plugs dont really like to hold mich weight either.

Hi MM,

Good point.
Just to clarify.

The mounting bolt very little bending loads, the weight of the coils is supported by the recess in the back of the mount
It mounts against the back of the boss, the COP engine bracket takes all of the loads

To give you an idea of how strong a bolt is, I lift out a whole 13B-REW (130kg) with a single M8 bolt with an eyelet

Either way the design is 'over designed by a safety factor of 100

Short of jacking up the car front the COP brackets you will never ever break them

[RICE RACING]

Originally Posted by Monkman33

But the single screw mounting point doesn't look like it would prevent the coils from vibrating. I would rather the cop link would not bear any weight. Since spark plugs dont really like to hold mich weight either.

Each 'F' and 'R' assembly does not take any weight through the bolt either as they sit on the extension leg from the COP engine bracket, just to clarify