Shotgun rebuild

[RETed]

Originally Posted by Ender

I Is this flywheel ok to use? It came off a different '87 TII and the marks around the edge are from my grubby hands, and it's only surface rust. I can't currently get the flywheel nut off the old motor so it's actually quite fortunate I had this (I just hope it's good to use), as has been the case with a lot of things in this build.

If it's just surface rust, just knock it off with a wire wheel.
Make sure there's no "bluing" of the steel, and the surface should be even.
It's highly recommended to get it resurfaced from a machine shop.


-Ted

[Ender]

Originally Posted by RETed

If it's just surface rust, just knock it off with a wire wheel.
Make sure there's no "bluing" of the steel, and the surface should be even.
It's highly recommended to get it resurfaced from a machine shop.

Cool. I'll probably look into a resurfacing tonight, if it's less than $30 I'd definitely do it...