New here but not to rotaries

RE_guru · 01-29-2010, 02:12 PM

Quote:

Originally Posted by reddozen

That's cool. I've been trying to figure out how I'm going to put it in the 7... I don't think it can run the factory RX7 gauge cluster, so I may have to do something similar to you and use the cluster and everything. yay for custom fiberglass work...

i have a friend that is great with fiberglass and will probably have him finish the dash out once i get it all mounted but tha project is a ways off i have to get my FC done.

RE_guru · 01-31-2010, 04:18 PM

picked this up from an imported here in St. Louis it was a little scratched up so i had the bar repowdered in "wet red" and the mounting plates in "wet black"

RE_guru · 02-02-2010, 04:02 AM

might be a little TOO tight.

01-31-2010, 04:18 PM	#2
RE_guru The Newbie Join Date: Jan 2010 Location: st. louis Posts: 24 Rep Power: 0	picked this up from an imported here in St. Louis it was a little scratched up so i had the bar repowdered in "wet red" and the mounting plates in "wet black" __________________ '94 Mazda Rx-7 montego blue '88 Mazda Rx-7 se (SOLD) '04 Mazda Rx-8 GT 6spd (daily) Control Freaks www.cfdrift.com All Your apex R belongs to US!

02-02-2010, 04:02 AM	#3
RE_guru The Newbie Join Date: Jan 2010 Location: st. louis Posts: 24 Rep Power: 0	might be a little TOO tight. __________________ '94 Mazda Rx-7 montego blue '88 Mazda Rx-7 se (SOLD) '04 Mazda Rx-8 GT 6spd (daily) Control Freaks www.cfdrift.com All Your apex R belongs to US!