New here but not to rotaries

reddozen · 01-29-2010, 11:49 AM

Quote:

Originally Posted by RE_guru

i would but i will probably get a front clip off a totalled car so i have all the parts i will need i will essentially put it in using the drive by wire and the cluster to save money nothing fancy.

That's cool. I've been trying to figure out how I'm going to put it in the 7... I don't think it can run the factory RX7 gauge cluster, so I may have to do something similar to you and use the cluster and everything. yay for custom fiberglass work...

RE_guru · 01-29-2010, 02:12 PM

Quote:

Originally Posted by reddozen

That's cool. I've been trying to figure out how I'm going to put it in the 7... I don't think it can run the factory RX7 gauge cluster, so I may have to do something similar to you and use the cluster and everything. yay for custom fiberglass work...

i have a friend that is great with fiberglass and will probably have him finish the dash out once i get it all mounted but tha project is a ways off i have to get my FC done.

RE_guru · 01-31-2010, 04:18 PM

picked this up from an imported here in St. Louis it was a little scratched up so i had the bar repowdered in "wet red" and the mounting plates in "wet black"

RE_guru · 02-02-2010, 04:02 AM

might be a little TOO tight.

01-31-2010, 04:18 PM	#3
RE_guru The Newbie Join Date: Jan 2010 Location: st. louis Posts: 24 Rep Power: 0	picked this up from an imported here in St. Louis it was a little scratched up so i had the bar repowdered in "wet red" and the mounting plates in "wet black" __________________ '94 Mazda Rx-7 montego blue '88 Mazda Rx-7 se (SOLD) '04 Mazda Rx-8 GT 6spd (daily) Control Freaks www.cfdrift.com All Your apex R belongs to US!

02-02-2010, 04:02 AM	#4
RE_guru The Newbie Join Date: Jan 2010 Location: st. louis Posts: 24 Rep Power: 0	might be a little TOO tight. __________________ '94 Mazda Rx-7 montego blue '88 Mazda Rx-7 se (SOLD) '04 Mazda Rx-8 GT 6spd (daily) Control Freaks www.cfdrift.com All Your apex R belongs to US!