FC3S Murray's never ending build.

[djmtsu]

Damn those look nice. Good work on your WORKs.

Makes me want to take apart those SSR's.........

[TitaniumTT]

Originally Posted by WE3RX7

Nice job! Would have gone gold, but ya know

Bill, I'ma go rent me a trailer and I'll see you in the morning so we can load your car up, bring to the land of good taste and you can go buy a scubie

Originally Posted by WE3RX7

On the powdercoating question, I've never had to seal a PC part against a non-PC part but I would think you would be ok to not sand it off. The only catch would be that the PC was applied properly and is level...if it has any dips/changes in elevation I would sand it off to be safe.

Agreed, as long as the coating is level, it shouldn't be a problem, however, if it went on thick, it may need to come down a bit.

Out of curiosity, as this was the debate that got me banned on the evil forum for calling out a newb on the subject, what temp were the centers baked too? was the temp brought down gradually? If you heat AL too much and/or bring it down too fast, you temper the material making it weaker. Now, I'm no metalurgist so I don't know the exact temps, but I do know that a standard powder like mine, that has to be baked @ 450*F is way to hot to use with wheels.

Originally Posted by djmtsu

Damn those look nice. Good work on your WORKs.

Makes me want to take apart those SSR's.........

SSR's you say You've got 3 months DJ!