FC3S Murray's never ending build.

WE3RX7 · 01-21-2010, 06:55 AM

Nice job! Would have gone gold, but ya know

Its always nice when you can bring something back like that though and it probably saved you a ton over getting new wheels.

On the powdercoating question, I've never had to seal a PC part against a non-PC part but I would think you would be ok to not sand it off. The only catch would be that the PC was applied properly and is level...if it has any dips/changes in elevation I would sand it off to be safe.

01-21-2010, 06:55 AM	#1
WE3RX7 RCC Addict Join Date: Feb 2008 Location: VA Posts: 1,812 Rep Power: 19	Nice job! Would have gone gold, but ya know Its always nice when you can bring something back like that though and it probably saved you a ton over getting new wheels. On the powdercoating question, I've never had to seal a PC part against a non-PC part but I would think you would be ok to not sand it off. The only catch would be that the PC was applied properly and is level...if it has any dips/changes in elevation I would sand it off to be safe.