Teach me about ignition - Rotary Car Club

		Rotary Car Club > Tech Discussion > RX-7 2nd Gen Specific (1986-92)
Teach me about ignition

RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections.

View Poll Results: Which ignition setup would you go for?
LSx Coils with bulkhead fittings through the firewall	0	0%
Coil on plug	0	0%
other (please explain)	4	100.00%
Voters: 4. You may not vote on this poll

Thread Tools

Display Modes

06-01-2010, 12:32 PM

#10

project86

Can't.Make.Up.My.Mind.

Join Date: May 2009

Location: Murfreesboro, TN

Posts: 1,377

Rep Power: 18

Quote:

Originally Posted by TitaniumTT

Last time I spoke with MoTeC they were going to grab a few of the coils that I did and run a few tests. I don't know if they have or not yet. I'm planning on calling them and sharing my results.

If you're referring to MoTeC's Denso COP, it's the LS1 and I gotta tell ya, I woldn't use it on the rotary after what I went though. I don't think they're all that special especially after wet-fouling them while the car was idling

Part number M DEN-580 to be exact

__________________
'90 GTUs
Stay up to date with my photography
'06 Toyota Highlander Hybrid
'10 Toyota Prius

"Initial Success or Total Failure"

Bookmarks

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -5. The time now is 08:13 AM.