Quote:
Originally Posted by WE3RX7
Nice job! Would have gone gold, but ya know  |
 Bill, I'ma go rent me a trailer and I'll see you in the morning so we can load your car up, bring to the land of good taste and you can go buy a scubie 
Quote:
Originally Posted by WE3RX7
On the powdercoating question, I've never had to seal a PC part against a non-PC part but I would think you would be ok to not sand it off. The only catch would be that the PC was applied properly and is level...if it has any dips/changes in elevation I would sand it off to be safe.
|
Agreed, as long as the coating is level, it shouldn't be a problem, however, if it went on thick, it may need to come down a bit.
Out of curiosity, as this was the debate that got me banned on the evil forum for calling out a newb on the subject, what temp were the centers baked too? was the temp brought down gradually? If you heat AL too much and/or bring it down too fast, you temper the material making it weaker. Now, I'm no metalurgist so I don't know the exact temps, but I do know that a standard powder like mine, that has to be baked @ 450*F is way to hot to use with wheels.
Quote:
Originally Posted by djmtsu
Damn those look nice. Good work on your WORKs.
Makes me want to take apart those SSR's.........
|
SSR's you say  You've got 3 months DJ!
__________________
-The Angry Stig-
DGRR 2009, 2011, 2012 & 2013 - Best FC
DEALS GAP!! WOOHOOOO!!!!!
2015 Audi S4 - Samantha - Zero Brap S4
2004 RX8 - Jocelyn - 196rwhp, 19mpg fuel to noise converter
2000 Jeep Cherokee Sport - Wifey mobile - Now with 2.5" OME lift and 30" BFG AT KO's! So it begins
1998 Jeep Cherokee - 5 spd, 4" lift, 33" BFG's - Rotary Tow Vehicle
1988 'Vert - In progress
1988 FC Coupe - Gretchen -The attention whore BEAST!
I'm a sick individual, what's wrong with you?
I'm pure Evil
I'm still insane, in the best possible way.
I think Brian's idea of romance is using lube.
Your rage caused the meteor strike in Russia. The Antichrist would be proud of his minion.
You win with your thread. Most everything
It's a truck with a steel gate on the back. Just a statement of fact
Motec M820, AIM dash, ported 13B-RE Cosmo, 6-spd trans, 4.3 Torsen, custom twin wg fully divided mani, Custom 4" split into 2x 3" exhaust, Custom HMIC, Custom custom custom custom I like to welder stuff....
No Bolt-ons allowed. Dyno'ed @ Speed1 Tuned by me - 405rwhp on WG.... WM50 cuming soon.
-Angry Motherf*cker Mode ENGAGED-
|