not starting tach not moving

rx7 FC TII · 09-09-2009, 11:42 AM

alright. not really sure whats going on. the car was running decent up till mon night when i drove back to tuscaloosa from birmingham. car was pretty bad on the hills and was bucking alot.

i got home shut it down and came back later to head to a friends and couldnt get it to start for a while. finally got it started and it ran the same as before but the bucking had gotten a little bit worse.

i have an rtek 2.1 but my palm pilot is dead so i cant check it till i go home and get the cable.

mon night when i got it to start the tach wouldnt even move. after i shut it down last night it would start right back up twice and the tach worked. now nothing. the tach doesnt even move when i try to start it.

any ideas?

rx7 FC TII · 09-09-2009, 12:00 PM

nevermind. i figured out its the wire that runs to the crank angle sensor. time for a new harness lol.

Red Dragon · 09-09-2009, 01:16 PM

cool glad to see it's ok Marshall

wanganwarrior · 09-09-2009, 01:51 PM

Check the wire going to your crank angle sensor

rx7 FC TII · 09-09-2009, 09:56 PM

haha thats exactly the wire it was lol.

and damn if the only new harness isnt $900 DAMN! lol

but the good news is im finally gonna get a new DP and get to tune it lol

09-09-2009, 01:16 PM	#3
Red Dragon Rotary Enthusiast Join Date: Apr 2008 Location: Birmingham, AL iTrader: (0) Posts: 129 Rep Power: 17	cool glad to see it's ok Marshall __________________ N/A 1987 RX7 (restoration coming along)

09-09-2009, 01:51 PM	#4
wanganwarrior Rotary Fanatic Join Date: Jul 2009 iTrader: (0) Posts: 108 Rep Power: 16	Check the wire going to your crank angle sensor