|
RX-7 3rd Gen Specific (1993-2002) RX-7 1993-2002 Discussion including performance modifications and Technical Support Sections. |
|
Thread Tools | Display Modes |
![]() |
#1 |
cxxxx|::::::::::::>
Join Date: Nov 2009
Posts: 315
Rep Power: 16 ![]() |
Fuel pump write up with pics
I removed my how to over on 7club for a few reasons. Figured i would put it here.
Disconnect your battery. Then the fuel pump access door is behind the Driver on a USDM spec FD. Lift up the carpet and you'll see it. If you have a Bose stereo system you'll probably have to remove it. There should be 4 screws holding the door down. ![]() Lift up the fuel door and unclip the wiring harness ![]() You can either unclip the ground or unscrew it i went with unscrewing it. ![]() Set the door off to the side and unscrew the fuel line connectors ![]() Clean off the area for obvious reasons ![]() Take all the screws out of the fuel hatch ![]() You'll need to push the 2 fuel lines out of the way. The line on the right hooks into a clip i found it easier to pull the line of the clip so you get more play in the line ![]() Lift out SLOWLY as to not hook the float on anything ![]() Remove the screw on the back of the rack, mine was extremely tight ![]() The + and - wires are different sizes so you can't really screw that up but hey maybe you can. I left 1 wire on just to make sure i didn't ![]() With the new fuel pump make sure and hook up the fuel bag thing by pressing on the washer ![]() Put the spacer and O-ring in the fuel neck ![]() Put the fuel pump space and cover on the fuel pump ![]() ![]() ![]() Tadaaa ![]() Put it all back in the car and start her up. I let my car idle for quite a while to make sure there was no air in the fuel lines. Please add in anything i might have forgotten. |
![]() |
![]() |
Bookmarks |
|
|