Installed new injectors, now it won't stay running

[speedjunkie]

Last week I put in Injector Dynamics 725cc primaries and 2000cc secondaries, replacing 1000cc and 1680cc injectors. I changed almost all the settings on the "settings 5" tab and I've tried with the injector map I had and I've tried tinkering with it, but no matter what else I do, the car will die if I don't keep revving the engine. I can't just hold it to a certain RPM because it will still putter out, so I have to keep blipping the throttle.

Not sure how many of these mods matter, but here they are:
-Power FC
-Large streetport 13B-REW
-A-Spec 500R
-725cc primary and 2000cc secondary Injector Dynamics fuel injectors
-CJ Motorsports fuel rails/kit
-MSD 8.5mm plug wires
-HKS Twin Power ignition
-Aeromotive fuel pressure regulator
-Supra fuel pump
-Kenne Bell BAP
-equal length lower intake manifold
-FJO water/methanol injection
-fast reacting air temp sensor

Can anyone see if there is something else wrong with my settings? Attached is a pic of my settings 5 tab.