Strut tower brace anyone?

warwickben · 03-23-2008, 09:50 AM

id be down for one for the rear since no one makes one. i wouldnt mind cutting the plastic .

this maybe be silly but to mount it. would you just remove the two nuts on the top of the shock's. thin out the top rubber mount a little bit then slide the strut bar over the two shock bolts? and reinstall the two set of double nuts? iam asking cause i have never seen up close how a rear strut bar mounts. if this is how it is done you could stamp the ends where the shock goes thru so it would act as the top washer. sorry if that makes no sense

03-23-2008, 09:50 AM	#1
warwickben sa rat rod Join Date: Mar 2008 Location: tewksbury ma Posts: 408 Rep Power: 18	id be down for one for the rear since no one makes one. i wouldnt mind cutting the plastic . this maybe be silly but to mount it. would you just remove the two nuts on the top of the shock's. thin out the top rubber mount a little bit then slide the strut bar over the two shock bolts? and reinstall the two set of double nuts? iam asking cause i have never seen up close how a rear strut bar mounts. if this is how it is done you could stamp the ends where the shock goes thru so it would act as the top washer. sorry if that makes no sense