|
|||||||
| RX-7 3rd Gen Specific (1993-2002) RX-7 1993-2002 Discussion including performance modifications and Technical Support Sections. |
|
|
Thread Tools | Display Modes |
|
|||||||
| RX-7 3rd Gen Specific (1993-2002) RX-7 1993-2002 Discussion including performance modifications and Technical Support Sections. |
|
|
Thread Tools | Display Modes |
06-16-2009, 11:58 PM
|
#7 |
|
Rotary Fanatic
Join Date: Mar 2008
Posts: 162
Rep Power: 18  |
You're right, that would be the cleanest. I just ordered a few feet of 3 conductor 18 gauge shielded wiring. If anything, I could also wrap the ends with the shielding also since that's also on the way. I'll post a pic after i finish.
One last question, I'm going to stagger the 3 solder points so that they're not all side by side. Is heat shrink tubing enough insulation for each wire? |
|
|
| Bookmarks |
|
|
Threaded Mode