Chickenwafer's Never Over Turbo 8 Build

chickenwafer · 06-15-2009, 04:03 PM

Now it's time for Teh Turbo!

Tearing out stock parts:

stock exhaust manifold out of the way. Renesis, weird exhaust ports:

New Garrett GT3071R twin ball bearing Turba!

The turbo in!

Not a whole lot of space:

You can barely see the compressor housing peaking through the manifold and motor mount:

FMIC all mounted up:

Custom aluminum cold air intake:

Had to extend the MAF harness:

Had to radius the downpipe holes for the dp nuts to clear:

Sort of finished, using a temp air filter until I could find one that fit behind the bumper

Installing a Snow Stage 2 Water/Meth kit:

Painted the solenoid and made a bracket to hold it:

Made some custom brackets to hold the tank and painted them as well:

And mounted the controller to the back of the tank and covered it with a piece of aluminum sheet to protect it.

Pump mounted on a custom bracket that mounts where the factory electric air pump goes:

Custom LS2 Yukon GM ignition coil setup:

06-15-2009, 04:03 PM	#4
chickenwafer Boost Whore Join Date: Jun 2009 Location: Northern Colorado Posts: 33 Rep Power: 0	Now it's time for Teh Turbo! Tearing out stock parts: stock exhaust manifold out of the way. Renesis, weird exhaust ports: New Garrett GT3071R twin ball bearing Turba! The turbo in! Not a whole lot of space: You can barely see the compressor housing peaking through the manifold and motor mount: FMIC all mounted up: Custom aluminum cold air intake: Had to extend the MAF harness: Had to radius the downpipe holes for the dp nuts to clear: Sort of finished, using a temp air filter until I could find one that fit behind the bumper Installing a Snow Stage 2 Water/Meth kit: Painted the solenoid and made a bracket to hold it: Made some custom brackets to hold the tank and painted them as well: And mounted the controller to the back of the tank and covered it with a piece of aluminum sheet to protect it. Pump mounted on a custom bracket that mounts where the factory electric air pump goes: Custom LS2 Yukon GM ignition coil setup: Last edited by chickenwafer; 06-15-2009 at 04:26 PM.