Front mount intercooler piping

[TitaniumTT]

Originally Posted by Phoenix7

Damn, how'd you piss them off?

I layed into some little nooblet in a PM, after a blankity blank blank admin told us to take the squable to PM's. Said little nooblet was on the verge of tears in a reply in which he gave me his cell phone #, so we could work it out I told him there was nothing to work out, he was wrong, he defended the fact that he was wrong but still right (yeah I don't know how that works either), wouldn't man up and he was acting like a little child. Nooblet forwarded the PM onto a napolean complex mod and perma-ban.

While the PM wasn't exactely my best work, it was suffiecient, I CC'ed a buddy on the humor so I still have the PM's in my e-mail, one of my mod friends was reading the PM in the mod section while I was on the phone with him. The tears of laughter left a mist of wet on my ears.

Originally Posted by vex

Normally I would but the ability to run front mount opens up a lot of possibilities that wouldn't readily be available to me otherwise.

Confused, explain please.

Originally Posted by vex

Not denying that absolute beauty of a V mount but I'm rearranging the entire engine bay already so doing a front mount shouldn't be all that much more difficult.

I would normally consider picking up a new intercooler as you have described but funds are going to be a little tight since I'm rebuilding my engine. I think I have the pipe mapped out in my head, but I would still appreciate pictures and the works of different F/V/H mount setups.

With alot of luck I'll have new pics in my hope to make it to DGRR thread in two weeks.

[vex]

Originally Posted by TitaniumTT

Confused, explain please.

sorry I had just woken up at that point. I meant along the lines of comparison to running a Top mount as way of cooling benefits, and V mount in the ability of opening up the engine bay for easier access to the engine. I've already cut up the front portion of the engine bay where the radiator sits. This is to allow the vertical mounting of the new radiator and provide me with around 3-4 inches of extra room towards the bottom of the engine. For this specific setup it doesn't mean much but my future plans (unknown date) will require a little more room from the engine. This also causes me to move the oil cooler about 2-3 inches forward from its current position (maybe not that much) further increasing the available room. As for comparison to the H-mount setups I'm not entirely sure how I would run it on my application or the difference in cooling benefits would be.

Once the mounting is complete I'll also have the ability to step up to a larger core on the intercooler just by dropping the old one and putting in the new one. There should be ample room for the increase in volume from the new intercooler in the future.