Turbo, RTV, Block off plates, and advice...

vex · 01-24-2009, 10:50 AM

Okay, so I checked compression on both rotors. I'm getting around 50-60psi on each face and a total compression of 100+psi (using piston compression tester) both front and rear.

I pulled the plugs and they're a little fouled. One of the leading plugs isn't looking too good as the piece in the middle has been warn away compared to the other one (not as pointy). When I pulled them however I noticed the first had alot of oil and and seemed well lubricated (front). When I pulled the second (rear) I noticed it had alot of oil and fuel mixture in it. I don't know why it's flooding on the rear when compression is so high.

Any thoughts on why a very good compression engine is flooding out?

(As a side note, I'm only able to secure trailing plugs right now. Would putting those in the leading position affect anything?)

01-24-2009, 10:50 AM	#1
vex RCC Loves Me Not You Join Date: Jul 2008 Location: Influx. Posts: 2,113 Rep Power: 20	Okay, so I checked compression on both rotors. I'm getting around 50-60psi on each face and a total compression of 100+psi (using piston compression tester) both front and rear. I pulled the plugs and they're a little fouled. One of the leading plugs isn't looking too good as the piece in the middle has been warn away compared to the other one (not as pointy). When I pulled them however I noticed the first had alot of oil and and seemed well lubricated (front). When I pulled the second (rear) I noticed it had alot of oil and fuel mixture in it. I don't know why it's flooding on the rear when compression is so high. Any thoughts on why a very good compression engine is flooding out? (As a side note, I'm only able to secure trailing plugs right now. Would putting those in the leading position affect anything?) __________________ The Official FC Radiator Thread My Project Thread: Cerberus CCVT Virginia Rotary Group Last edited by vex; 01-24-2009 at 12:16 PM.