PB Blaster + CAS = ??

need RX7 · 01-10-2009, 04:48 PM

Last night I was spraying PB blaster on some bolts in the engine bay, and I happened to have the CAS cover off. I got a little trigger-happy and ended up getting some in the CAS. Is this bad? I dried out what I could with a paper towel (it wasn't much really). I haven't tried starting it since (main pulley is off) but could this damage the CAS?

vex · 01-10-2009, 04:54 PM

not likely. Damage of electrical components would come from the electric current going places it shouldn't or in too many amps. I'd recommend getting some electrical cleaning spray (basically an alcohol) and spray it in there if you're worried about it. Let it dry out and inspect it. If you're still concerned with it do an FSM test on it.

01-10-2009, 04:48 PM	#1
need RX7 Clean S4 Nutswinger Join Date: Mar 2008 Location: Sterling Heights, MI iTrader: (0) Posts: 485 Rep Power: 17	PB Blaster + CAS = ?? Last night I was spraying PB blaster on some bolts in the engine bay, and I happened to have the CAS cover off. I got a little trigger-happy and ended up getting some in the CAS. Is this bad? I dried out what I could with a paper towel (it wasn't much really). I haven't tried starting it since (main pulley is off) but could this damage the CAS? __________________ -Ted -1986 Mazda RX7 Sport [DD/beater]: engine finally let go at 205k. parts car status. -1986 Mazda RX7 base [resto-mod project]: S5 n/a swap in progress.

01-10-2009, 04:54 PM	#2
vex RCC Loves Me Not You Join Date: Jul 2008 Location: Influx. iTrader: (6) Posts: 2,113 Rep Power: 19	not likely. Damage of electrical components would come from the electric current going places it shouldn't or in too many amps. I'd recommend getting some electrical cleaning spray (basically an alcohol) and spray it in there if you're worried about it. Let it dry out and inspect it. If you're still concerned with it do an FSM test on it. __________________ The Official FC Radiator Thread My Project Thread: Cerberus CCVT Virginia Rotary Group