FD3S RX-7 Engine Mounted Oil Catch Tank GB

[RotaryWhat?]

Originally Posted by afgmoto1978

RotaryWhat? how do you plan on routing your turbo ducting? If you plan on having the tubing go over the region of where this pre-mix tank is I will have to account for it.

Good question. I don't have tubing from the intercooler made yet, so there is some room for adjustment of this piping. I would think the premix tank filler cap would need to be as close to the alternator as possible (still allowing for adjustment of the alt. & bracket), and as close to engine oil fill cap as possible. I've attached a picture of Goodfella's car (hope he doesn't mind) which has the same LIM, Greddy TB Elbow, and Blitz Intercooler as I do---so my piping should run somewhat similar to this. I can't really say for sure though, as I will be keeping the power steering and don't know how that will affect the routing.

Not sure if that helps you or not, and I can't really take measurements until I have the engine back in the car with the intercooler.