My engine build

AHarada · 09-11-2008, 06:44 PM

I dropped off my irons and housings to Rene at RMS (Rene's motors sports). He did an awesome port job. I talked it over with him a little and we decided a fairly big streetport was what I was looking for. HP figures are up in the air, but just in case later on I want to go for big numbers, we installed heavy duty studs to address flexing. There are 4 of them, and I reused the stock tension bolts on the other holes. He bored out the holes through all of the housings (the studs are larger diameter than stock) and made threads in the front iron.

09-11-2008, 06:44 PM	#1
AHarada Rotary Fanatic Join Date: Mar 2008 Posts: 162 Rep Power: 18	Porting, waiting for parts, etc. I dropped off my irons and housings to Rene at RMS (Rene's motors sports). He did an awesome port job. I talked it over with him a little and we decided a fairly big streetport was what I was looking for. HP figures are up in the air, but just in case later on I want to go for big numbers, we installed heavy duty studs to address flexing. There are 4 of them, and I reused the stock tension bolts on the other holes. He bored out the holes through all of the housings (the studs are larger diameter than stock) and made threads in the front iron.