Intercooler mist cooling system

mazdamaniac · 07-16-2008, 02:29 AM

Water/meth injection.

Don't waste the spray - put it into the motor.
It works and provides a result significantly better than that provided by cooling the outside of the intercooler.

I run an AEM kit, which is MAP-based.
I can get below ambient charge temps and instant, unfaltering detonation prevention in all ambient conditions - even this 115° Phoenix heat and 41 lbs/min of air - for the full duration of a tank of gas on just a 1/2 gallon of $1 washer fluid.
Instant power, too. Even without re-tuning for it, you will see a significant increase in torque.

07-16-2008, 02:29 AM	#1
mazdamaniac Rotary Fan in Training Join Date: Jul 2008 Location: Under my car Posts: 99 Rep Power: 18	Water/meth injection. Don't waste the spray - put it into the motor. It works and provides a result significantly better than that provided by cooling the outside of the intercooler. I run an AEM kit, which is MAP-based. I can get below ambient charge temps and instant, unfaltering detonation prevention in all ambient conditions - even this 115° Phoenix heat and 41 lbs/min of air - for the full duration of a tank of gas on just a 1/2 gallon of $1 washer fluid. Instant power, too. Even without re-tuning for it, you will see a significant increase in torque. __________________