RXtacy's slooow build up

[RXtacy]

Originally Posted by speedjunkie

Nice bracket! I made one for the stock location too but they sit closer to the edge of the engine and yours is finished better lol.

Thanks, finally getting a belt sander has dramatically improved the finish quality Are you using the IGN-1A also? They're not small coils. It was really damn tight under there between the UIM and the fuel lines.

[speedjunkie]

Originally Posted by RXtacy

Thanks, finally getting a belt sander has dramatically improved the finish quality Are you using the IGN-1A also? They're not small coils. It was really damn tight under there between the UIM and the fuel lines.

I didn't sand or coat mine or anything lol. It looks pretty rough. Yeah I'm using those coils too. I had to remove the coolant outlet nipple on the bottom of the throttle body to get it to almost sit on top of the coils (it's that tight), but I wanted short plug wires and that's what I got lol. I just need to figure out a way to duct cool air to them or wrap them in reflective barrier. I'll see if I can find a pic so you can see how they sit. Although it doesn't really matter since you did yours already lol and I'm not trying to hijack.

EDIT: Here we go.

[RXtacy]

Originally Posted by speedjunkie

I didn't sand or coat mine or anything lol. It looks pretty rough. Yeah I'm using those coils too. I had to remove the coolant outlet nipple on the bottom of the throttle body to get it to almost sit on top of the coils (it's that tight), but I wanted short plug wires and that's what I got lol. I just need to figure out a way to duct cool air to them or wrap them in reflective barrier. I'll see if I can find a pic so you can see how they sit. Although it doesn't really matter since you did yours already lol and I'm not trying to hijack.

EDIT: Here we go.

Looks good to me
I like how far over you got them. Would have made my fuel line routing easier. Mine are quite close to the UIM as they sit.