|
|||||||
| Fabrication Show off the parts that you've built from scratch or highly modified |
 |
|
|
Thread Tools | Display Modes |
|
|||||||
| Fabrication Show off the parts that you've built from scratch or highly modified |
|
|
|
Thread Tools | Display Modes |
|
|
11-15-2015, 06:31 PM
|
#1 |
|
Lifetime Rotorhead
Join Date: Apr 2010
Location: Elkton, MD
Posts: 874
Rep Power: 16  |
Calling this "fabrication" is a bit of a stretch, but if anyone is building up a rotary and is lacking the spendy tool needed to measure step wear on the plates, this little bracket thingy I made and a standard dial indicator will do the job rather well. All this is is a chunk of solid AL bar stock and an AL right angle piece bolted to it, that I bolted the dial indicator to. Pictures describe it better than words...
|
|
|
| Bookmarks |
|
|
Hybrid Mode
