|
|||||||
| Show your rotary car build up. Show off your Rotary Car build! |
![]() |
|
|
Thread Tools | Display Modes |
|
|
|
|
#1 | |
|
⊙⊙
Join Date: Dec 2009
Location: Great Falls
Posts: 1,258
Rep Power: 17 ![]() |
You lost your boot sole....
__________________
Quote:
|
|
|
|
|
|
#2 |
|
Professional Stick Poker
Join Date: Feb 2011
Location: Stafford, Ks.
Posts: 1,016
Rep Power: 16 ![]() |
It's outta here!
I was cringing a bit when I started making the cuts, but it had to be done to get a decent sized muffler and fuel tank in there.... and the position where the muffler is going to fit. muffler position by Kevin Frank, on FlickrI'm going to lose about 6.5 inches of boot ( ) space due to raising the floor that far. It will allow me to fit the muffler, with plenty of air space around it, and to fit a standard 20 gallon fuel cell (24x20x10) if that's what I end up going with. The bottom edge of the muffler and the fuel cell will project below the car by about 2 inches, but I don't think that should be a problem. It's not a 4x4 and departure angle shouldn't be too big of a worry.
__________________
1988 N/A SE 2+2, dead stock and staying that way. ![]() 1979 SA22C stock? Not so much. http://rotarycarclub.com/rotary_foru...ad.php?t=15585 Last edited by GySgtFrank; 07-08-2015 at 05:34 PM. |
|
|
|
|
#3 |
|
Rotary Fanatic
Join Date: Mar 2008
Location: Freedom Land
Posts: 316
Rep Power: 18 ![]() |
Looks good.
__________________
This is going to tear |
|
|
![]() |
| Bookmarks |
|
|