|
|||||||
| RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
|
|
Thread Tools | Display Modes |
|
|||||||
| RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
|
|
Thread Tools | Display Modes |
11-04-2013, 03:01 PM
|
#2 |
|
rotaryevolution.net
Join Date: Feb 2011
Location: Las Vegas, NV
Posts: 248
Rep Power: 15  |
unless you turned the motor or bumped the shaft it should be ok. put the pulley back on and start cinching it down slowly, if the bearing fell it will begin to get difficult to turn after the bolt is snug, at which point the cover needs to come off.
__________________
http://rotaryevolution.net |
|
|
| Bookmarks |
|
|
Threaded Mode