|
|||||||
| RX-8 (2004 - Present) All things to do with RX-8 |
|
|
Thread Tools | Display Modes |
|
|||||||
| RX-8 (2004 - Present) All things to do with RX-8 |
|
|
Thread Tools | Display Modes |
03-01-2008, 11:26 PM
|
#4 |
|
Rotary Fanatic
Join Date: Feb 2008
Location: Chattanooga, TN
Posts: 318
Rep Power: 18  |
The next step is to install the braces. They fit over the stock bolt locations and make use of the factory nuts. It is impossible to mix the brade sides up. the rear bolt on each side sits further back than the front bolt and the braces are designed for this.
Set the braces on and bolt them down. Be sure you go back over each of the nuts after you tighten all around since as you go around it will pull the piece in quite a bit more and will mean some of your nuts will not be tight anymore. The picture shows the braces bolted in.
__________________
93 bb rx7 Destined to be the never ending project car or possible part source for the rotary rat rod 2008 40th Anniversary Edition RX-8 - bankruptcy owned me RE-Amemiya Super Dolphin Tail Exhaust-for sale AutoExe Front and Rear Strut Bars-for sale AutoExe Member Brace Set-for sale 2008 Honda CBR600RR - bankruptcy owned me Motivation axle/fork/barend/frame sliders ASV "unbreakable" shorty levers Tripage Integrated Tailight and Adj FE Proton Fushmounts Akrapovic Hex Carbon/TI Slip On Sato Rearsets |
|
|
| Bookmarks |
|
|
Threaded Mode