im back in an FC!!

88turboii · 07-21-2013, 10:49 AM

Quote:

Originally Posted by WE3RX7

How was installing the turblown stud kit? Pretty simple to just swap em out for the tension bolts and call it a day?

yes super simple, they are threaded on both sides, but have an allen wrench fitting on one end to make it easy to thread into the front iron, then you just torque the nut to spec

WE3RX7 · 07-21-2013, 02:55 PM

Quote:

Originally Posted by 88turboii

yes super simple, they are threaded on both sides, but have an allen wrench fitting on one end to make it easy to thread into the front iron, then you just torque the nut to spec

Sweet, didn't know if they were stock sized or if milling was needed. I will probably go this route on the next engine I put together....