Heat Shield vs. Turbo Blanket

RICE RACING · 12-05-2012, 09:31 PM

Very old pics from about 5 years ago, lots of iterations since then. Need to take some new ones.

The heat shield remains, no loose wrap sheets anywhere on any pipes, only a bag on the turbine housing (currently use a DEI one).

RICE RACING · 12-05-2012, 09:34 PM

But yes pic from underneath on a dummy engine when I was fabricating and placing parts for welding etc.

the header heat shield is fully sealed to the motor and the turbine flange, takes a fair bit to make it this way and must be done in two pieces, made out of 316 and bolted together and held on top side by EGT bungs on each pipe.

The down pipe shiled is held by the AFR sensor, agian no pics of this only old ones.

12-05-2012, 09:31 PM	#1
RICE RACING Don Mega Join Date: Dec 2008 Location: Utopia Posts: 1,688 Rep Power: 18	Very old pics from about 5 years ago, lots of iterations since then. Need to take some new ones. The heat shield remains, no loose wrap sheets anywhere on any pipes, only a bag on the turbine housing (currently use a DEI one). __________________ www.riceracing.com.au Worlds best Apex Seals Coil on Plug Water Injection ECU Calibration

12-05-2012, 09:34 PM	#2
RICE RACING Don Mega Join Date: Dec 2008 Location: Utopia Posts: 1,688 Rep Power: 18	But yes pic from underneath on a dummy engine when I was fabricating and placing parts for welding etc. the header heat shield is fully sealed to the motor and the turbine flange, takes a fair bit to make it this way and must be done in two pieces, made out of 316 and bolted together and held on top side by EGT bungs on each pipe. The down pipe shiled is held by the AFR sensor, agian no pics of this only old ones. __________________ www.riceracing.com.au Worlds best Apex Seals Coil on Plug Water Injection ECU Calibration