800+rwhp 13B PP

[forcefed7]

Originally Posted by RICE RACING

For the motor:

It's bridge and peripheral ported

-Semi PP with street port.

Originally Posted by RICE RACING

Ceramic apex seals

-no, 2mm steel

Originally Posted by RICE RACING

What exact turbo specification?

-GT4202R

Originally Posted by RICE RACING

fuel system detail?

-6 x 160lbs injectors

Originally Posted by RICE RACING

race clearanced rotors?

-yes

Originally Posted by RICE RACING

what compression ratio?

-slightly less then 9:1

Originally Posted by RICE RACING

what crank shaft if not standard?

-reworked stock mazda shaft

Originally Posted by RICE RACING

How big is the exhaust system post turbo?

-4" with two muffler

Originally Posted by RICE RACING

is the waste gate plumbed back?

-no

Originally Posted by RICE RACING

Pro EFI (how good is it) on staging it has a mis in the video? *see note on fuel system specs*

-Very good, still needed accel table adjustments

Originally Posted by RICE RACING

what exact fuel do you run in it?

-93 octane, VPC16, or Q16

Originally Posted by RICE RACING

what AFR

-whatever the engine needs depending on load.

Originally Posted by RICE RACING

What ignition system?

-inductive ignition system.

Originally Posted by RICE RACING

how much timing on 350kpa ABS?

-whatever the engine needs depending on load and charge density.

Originally Posted by RICE RACING

Congrats on the power and the nature of it, it is exceptional

If you e-mail me I'm sure I will get you a tester shipped from one of my friends there asap

[RICE RACING]

What AFR can your induction ignition system handle on 350kpa boost, I assume you are limited to what you can run with it? Same for advance? what is the maximum power you ran on 93 octane alone?