FS: My GSL-SE '85 :(, $1300 obo

WE3RX7 · 04-16-2008, 07:54 PM

Basically, I did a final rough coat of filler on the quarter which I havent sanded down yet, but probably will this weekend (going to be nice!)

Skimmed drivers door and there are two spots on the hood where I was playing with colors to figure out what I was going to paint the car...

The interior is near perfect as I've been restoring it. Needs the rear plastic dyed back to gray (sun faded), and a factory radio (i have one, but not sure if it works yet). There is a little sun spot on the dash too which needs a little touch up. It has door pull plastic cups as well.

This was a restoration project that is about 70% there. Just needs the final sand down and paint to be a damn nice car. I do have the new header panel, just not installed....

I will continue to work on the car, but better believe, if I paint it before it sells, it'll look good and the asking $ goes up,lol...

04-16-2008, 07:54 PM	#1
WE3RX7 RCC Addict Join Date: Feb 2008 Location: VA Posts: 1,812 Rep Power: 19	Basically, I did a final rough coat of filler on the quarter which I havent sanded down yet, but probably will this weekend (going to be nice!) Skimmed drivers door and there are two spots on the hood where I was playing with colors to figure out what I was going to paint the car... The interior is near perfect as I've been restoring it. Needs the rear plastic dyed back to gray (sun faded), and a factory radio (i have one, but not sure if it works yet). There is a little sun spot on the dash too which needs a little touch up. It has door pull plastic cups as well. This was a restoration project that is about 70% there. Just needs the final sand down and paint to be a damn nice car. I do have the new header panel, just not installed.... I will continue to work on the car, but better believe, if I paint it before it sells, it'll look good and the asking $ goes up,lol... Last edited by WE3RX7; 02-04-2009 at 11:50 PM.