|
Show your rotary car build up. Show off your Rotary Car build! |
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
S4 Owner
Join Date: Jun 2008
Location: Tottenham, ON, Canada
Posts: 48
Rep Power: 0 ![]() |
I want more, hurry up man!
__________________
1985 Mazda RX7 GSL 13B, Holley etc 1997 Mazda MX6 LS - DD lowered on 17s |
![]() |
![]() |
#2 |
IT'S ALIVE!
Join Date: Dec 2009
Location: Richmond, VA
Posts: 811
Rep Power: 16 ![]() |
Ha, I didn't know anyone was actually following this! Funds are low right now so I've had to slow down a bit. I can't do too much without the intake manifold anyway.
I've been focusing on the interior while I save up some money. I've completely removed the stock restraint system, and I've got a Kirk Racing roll bar out getting powdercoated that will likely go in tomorrow. Since I no longer have a rear wiper and the OEM service panels are NLA I went and made my own out of .025" aluminum again. I may have stripped all the luxury out of this car but that doesn't mean it has to look like crap. ![]() A shot of the interior in its current state: ![]() After the roll bar it's just seats and harnesses and the interior is done. |
![]() |
![]() |
#3 |
I have radioactive semen
Join Date: Jul 2008
Location: in a bottle of Glenfiddich
Posts: 249
Rep Power: 17 ![]() |
nonsense, dude! hell, you've given me an idea or two regarding my Gen II. i, too, am building on a 4-port setup, but there are a few little differences here and there because it may or may not remain N/A.
however, i love the way yours is coming together. i really dig your IDA throttle. i came pretty close to buying one, too, but i eventually went with TWM. i can't wait to see what Logan comes up with for your intake manifold. just keep up the good work, brother! i'm sure i'm not the only one following. ![]() |
![]() |
![]() |
Bookmarks |
|
|