Shotgun rebuild

[Ender]

I looked at them again, and they really weren't in bad shape. Except CarX SCREWED ONE OF THE BEARINGS UP AND DIDN'T TELL ME!! I am furious. It would have been one thing if they had told me it happened, but now I have no choice but to replace all of them and they gave me my parts box back without a word about their condition. I'm calling them today to request they help pay to have the bearings replaced. I would have been able to reuse these without any problems and I was going to do just that until I discovered this.

This is the one, you can't tell well because it's blurry, but it's very obvious on both sides that whatever disc they used slipped.

[RETed]

Originally Posted by Ender

This is the one, you can't tell well because it's blurry, but it's very obvious on both sides that whatever disc they used slipped.

Okay, the pics are that bad that I'm not quite sure what you're trying to describe?

The two later ones with the stat gears are fine.
The copper showing on the *seam* of the bearing is okay.

I'm not too sure what is wrong with the bearing on the rotor is?
If anything it looks like it slipped out a little?
If so, you can just press it back in; just make sure the "tab" is aligned correctly.
Else, I don't see any major copper areas showing.


-Ted