TitaniumTT's from scratch Track Trailer

[TitaniumTT]

Sadly though, the BBS wheels still wouldn't fit. That last 1/4" of the new hub that protrudes past the spacer is too large to fit inside the hub off the 'vert wheels. It's off by .0150" Looks like my machinist will have a job 11/7 turning those down ever so slightly... oh well.

Regardless, I used the ASA rims that I've been wanting to sell to set up the fenders. The diameter is the same and the offset was off by 2mm, close enough for fenders. So with the fenders mounted and the new rims, I went to go get the trailer inspected.... it failed. Apparently I was short 4 lights..... Damn I hate the DMV with a passion. I needed a set of red markers in the rear, and a set of amber markers in the front. The fronts were damn easy, the rears were a pain, only finding a spot for them. Once I found a 1" LED with a .75" ID that would fit in the fender support, I was set. Snaking the wire was also pretty easy Here's the fender supports with the axle removed



Here's a pic of the light and the snaking



Once I had the lights all set and I felt that the thing was ready for another inspection, I set about getting a much better way to secure the tanks other than the ratcheting strap and a piece of line. Effective, just not sexy. These tie-downs I've used in the past. I love em. With the hoop removed, al that remains is an anodized dome piece of AL.... and they're supposed to support 2000lbs to boot... I kinda doubt it's that much but whatever.

Here it is secured



To remove it, you grab the almost H shapped piece, pull up, and slide out



Very very quick. But now I needed the same quick and sexy way to get tension on the webbing. I looked at a few different options before deciding on these straight pull latches from De-Sta-Co. I actually used this same latch on the rear swing out on my Cherokee, just a much bigger one. These aren't doing much bit tensioning some webbing to secure a 50lb tank of gas. Don't need all that much so the smaller was definitely the way to go.

Released with no tension



TENSION!

Yup, lots of tension, hold the tank really snug.





The last little bit that I can think of is a way to quickly and easily secure the tires themselves. I know exactely how to do it, I just need a tubing bender and I'll be ready to roll with that.

Then, break the whole thing down, powdercoat it and then put it in storage till the spring

[TitaniumTT]

Need more pics