All motor 12a rebuild.

Tri-Angles · 07-16-2011, 03:13 AM

Quote:

Originally Posted by Gravity Fed

technically speaking it can work and you seem aware that it wouldn't see its full potential. I have a good deal on a weber 48 ida from my streetport 12a. Thing ran damn good! Lots of spare jets with it if you choose to bypass the work and cost of rejetting the niki

Ok. How much would you sell it for if you were to sell it? And if not what size jets could I use on my nikki to make this work. Im making my order for my gasket kit tomorrow or sunday but i wont be able to get my rotor kit until maybe 2 weeks from now. My biggest thing would be getting my intake and carb because im on a tight budget because im starting UTI in sept. :-/

Tri-Angles · 07-16-2011, 03:17 AM

And here is the link to ausrotary where i have a few pics of the j port that i did on my plates. I havent finished my intake ports yet. Im not going to go too high on my centre plates intake ports though. http://www.ausrotary.com/viewtopic.p...3584&start=100

07-16-2011, 03:17 AM	#2
Tri-Angles The Newbie Join Date: Dec 2010 Posts: 8 Rep Power: 0	And here is the link to ausrotary where i have a few pics of the j port that i did on my plates. I havent finished my intake ports yet. Im not going to go too high on my centre plates intake ports though. http://www.ausrotary.com/viewtopic.p...3584&start=100 Last edited by Tri-Angles; 07-16-2011 at 09:58 PM. Reason: Forgot the link