Replace the oil returm line with JIC fittings and braded line

Garfinkles Motor Works · 03-28-2011, 10:35 PM

Mail the trace to David Garfinkle
29 Wind Walker Ct
Manchester Tn. 37355
Use a sharp pin and remember the part will not be any better than the drawing because I can not trial fit before shipping . Trace the part three times to be sure .My parts usually fit very well .How many do you need ? I do not have a gasket for the motor ,wait untill you get yours or ask some one on the forun to help .If you need a little more working room in the area I think a size - 6 will be big enough .The ones for the third gen are a size 8 in the pictures . -8 is 1/2 inch -6 is 3/8 inch .The -8 is a tight fit .David

03-28-2011, 10:35 PM	#1
Garfinkles Motor Works RCC Contributor Join Date: Mar 2008 Posts: 535 Rep Power: 18	Mail the trace to David Garfinkle 29 Wind Walker Ct Manchester Tn. 37355 Use a sharp pin and remember the part will not be any better than the drawing because I can not trial fit before shipping . Trace the part three times to be sure .My parts usually fit very well .How many do you need ? I do not have a gasket for the motor ,wait untill you get yours or ask some one on the forun to help .If you need a little more working room in the area I think a size - 6 will be big enough .The ones for the third gen are a size 8 in the pictures . -8 is 1/2 inch -6 is 3/8 inch .The -8 is a tight fit .David