|
Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Rotary Masochist
Join Date: May 2008
Location: Floyds Knobs, IN
Posts: 494
Rep Power: 18 ![]() |
I would use something like this versus the little probes that you stick in the radiator fins. Drill and tap the back of the water pump below the thermostat and you're ready to go. These types of switches are available in different temp ratings. I would definitely want the fan to come on sooner than it has been in your case.
http://www.amazon.com/Sierra-TEMPERA.../dp/B001RIJGPO
__________________
_______________________________________________ One stop Haltech, AEM, Syvecs shopping. Installation and tuning. http://www.lms-efi.com Free support. Drop us an email. chris@lms-efi.com 502-515-7482 Facebook @LMS-EFI |
![]() |
![]() |
![]() |
#2 |
Waffles - hmmm good
Join Date: Aug 2008
Location: Huntersville, NC
Posts: 757
Rep Power: 0 ![]() |
How is the fan relay wired up to operate from the temp sensor? Just the
sensor input alone won't trigger that relay I expect. There must be thermal switch inline with the relay that needs to know the temp. Maybe when you replaced the old setup it lost that input along the way?
__________________
1980 GS stockport, Fat Nikki, RB Dual Facetfuel pumps, Holley regulator, RB Street port exhaust, 2GDFIS, MR2 MK I electric fans, 2G strut bar, relayed fans, lights and fuel pump, LEDs Project Fat Nikki Budget 12A rebuild Video setup < $30.00 |
![]() |
![]() |
![]() |
Bookmarks |
|
|