Go Back   Rotary Car Club > Tech Discussion > RX-7 2nd Gen Specific (1986-92)

RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections.

Reply
 
Thread Tools Display Modes
Old 08-12-2010, 06:41 PM   #1
NoDOHC
The quest for more torque
 
NoDOHC's Avatar
 
Join Date: Sep 2008
Location: Sheboygan, Wisconsin
Posts: 855
Rep Power: 17
NoDOHC will become famous soon enough
Quote:
Keep in mind that if you go lightweight FW, you will lose torque.
Although the launch is a little weaker becuae you lose engine inertia relative to vehicle inertia (which barely changes with the little bit of weight you save) if you look at the engine and drivetrain as a whole, where would the lighter flywheel put the torque - if it were causing you to lose it?

Anyway, I went from a stock flywheel to the Fidanza, I picked up 0.2 seconds in the 1/4 mile. (13.4 to 13.2) with a completely stock RX7.

I didn't notice that the launch was that difficult with a stock-type clutch in the car.

I now have a RB 12 lb turbo flywheel in the car with a spec stage 3+ clutch and it is a bit challenging to get it moving without a smoky burnout, but I don't blame the flywheel.

Your idle may not be as smooth.
__________________
1986 GXL ('87 4-port NA - Haltech E8, LS2 Coils. Defined Autoworks Headers, Dual 2.5" Exhaust (Dual Superflow, dBX mufflers)
1991 Coupe (KYB AGX Shocks, Eibach lowering springs, RB exhaust, Stock and Automatic)
NoDOHC is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:23 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com