Go Back   Rotary Car Club > Tech Discussion > RX-7 2nd Gen Specific (1986-92) > Archives

Archives All the stickies in one place

Reply
 
Thread Tools Display Modes
Old 03-28-2008, 07:41 AM   #1
N.RotaryTech
Home-brew Rotary
 
N.RotaryTech's Avatar
 
Join Date: Feb 2008
Location: GooseCreek SC
Posts: 552
Rep Power: 18
N.RotaryTech is on a distinguished road
While rebuilding my S4 NA engine, measured with bathroom scale...so...

Rotors: 9 lbs ea. = 18 lbs
Housings: 12 lbs ea. = 24 lbs
Eccentric shaft: 14 lbs
Front Iron: 22 lbs
Middle Iron: 27 lbs
Rear Iron: 26 lbs
Front cover: 4 lbs
Stationary gears: 6 lbs
Oil pan: 4 lbs
All engine bolts: 10 lbs
(oil pump, bearings, counter weight, chain & gears, engine pins, oil pick-up tube, oil filter pedestal, op sensor, etc.): 10 lbs

Total: 165 lbs
I guess this is considered a "short block".
__________________
'89 RX7 GTU, half-Bridge-port S4/S5 NA, E6K, Full RB exhaust, weekend warrior.
'83 RX7, The "this might take awhile" project.
'87 RX7 GXL, Rest In Pieces.
'98 Subaru Impreza Outback-sport, rx7 rescue vehicle, down for repair.
'94 Ford Ranger, daily.
N.RotaryTech is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:38 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com