Project FD3S (Not 56K Friendly)

BigIslandSevens · 01-31-2010, 08:09 PM

Nice build. Yes, progress on these cars can take some time unless you have deep pockets. even then unless you do your own work it takes a loong time. And even then....

Speedjunkie:

I think that i have a dash removal write up if your intrested in that.

Dave

speedjunkie · 01-31-2010, 11:32 PM

Quote:

Originally Posted by 93rx7r1

Pulling the dash isn't too bad really. Just take your time and do it right. I went with out heat for a while too. I actually had the heater core looped out of the system for about 8 months LOL

Mine has been looped out of the system for almost two years now haha.

Quote:

Originally Posted by BigIslandSevens

Speedjunkie:

I think that i have a dash removal write up if your intrested in that.

Dave

I'm absolutely interested in that, thanks!

93rx7r1 · 02-01-2010, 06:17 AM

Quote:

Originally Posted by BigIslandSevens

Nice build. Yes, progress on these cars can take some time unless you have deep pockets. even then unless you do your own work it takes a loong time. And even then....

Thanks. I don't really mind just taking my time and building the car. It's fun! I do most of my own work. I did have KD Rotary do the porting and engine rebuild to it was done right and because I lacked the tools and knowledge, but I'm learning these rotary engines!

01-31-2010, 08:09 PM	#1
BigIslandSevens Rotary Fanatic Join Date: Feb 2008 Location: Denver, NC Posts: 201 Rep Power: 18	Nice build. Yes, progress on these cars can take some time unless you have deep pockets. even then unless you do your own work it takes a loong time. And even then.... Speedjunkie: I think that i have a dash removal write up if your intrested in that. Dave Last edited by BigIslandSevens; 01-31-2010 at 08:14 PM.