|
Show your rotary car build up. Show off your Rotary Car build! |
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Pirate
Join Date: Mar 2008
Location: Central IL
Posts: 1,323
Rep Power: 19 ![]() |
damn, so 80 dyno pulls at around $100 per hour... assuming we're talking around a 1pull/ hour average here, that's around $8,000!
__________________
Rotaries:They are NOT that complicated! |
![]() |
![]() |
![]() |
#2 | ||
Test Whore - Admin
Join Date: Mar 2008
Location: Right Behind you son
Posts: 4,581
Rep Power: 10 ![]() |
![]() Me loves my Magnaflows Thanks Quote:
Quote:
![]() Negative, no where near that. Dave's pricing structure is no where near greedy like alot of the other shops around. Factoring in the $60+ worth of gas I need to get there and back.... not to mention we use between 1/8 and a 1/4 tank ON the dyno, it's still way cheaper than going at it local. Dave is just a hell of a guy in generaland bills what he thinks is fair. His tuning/dyno is not billed on an hourly basis and that's all I'm going to say. Dollars in vs his expertise, time and everything else, it's honestly worth a drive from hundreds of miles away, a hotel room if needed, and maybe an internal organ to go see him. That may be why his que is pretty busy and he has clients that cross more than 6 state borders sometimes. I literally could go on for hours about him..... in fact, see below.
__________________
-The Angry Stig- DGRR 2009, 2011, 2012 & 2013 - Best FC DEALS GAP!! WOOHOOOO!!!!! 2015 Audi S4 - Samantha - Zero Brap S4 2004 RX8 - Jocelyn - 196rwhp, 19mpg fuel to noise converter 2000 Jeep Cherokee Sport - Wifey mobile - Now with 2.5" OME lift and 30" BFG AT KO's! So it begins 1998 Jeep Cherokee - 5 spd, 4" lift, 33" BFG's - Rotary Tow Vehicle 1988 'Vert - In progress 1988 FC Coupe - Gretchen -The attention whore BEAST! I'm a sick individual, what's wrong with you? I'm pure Evil I'm still insane, in the best possible way. I think Brian's idea of romance is using lube. Your rage caused the meteor strike in Russia. The Antichrist would be proud of his minion. You win with your thread. Most everything It's a truck with a steel gate on the back. Just a statement of fact Motec M820, AIM dash, ported 13B-RE Cosmo, 6-spd trans, 4.3 Torsen, custom twin wg fully divided mani, Custom 4" split into 2x 3" exhaust, Custom HMIC, Custom custom custom custom I like to welder stuff.... No Bolt-ons allowed. Dyno'ed @ Speed1 Tuned by me - 405rwhp on WG.... WM50 cuming soon. -Angry Motherf*cker Mode ENGAGED- Last edited by TitaniumTT; 11-09-2009 at 11:33 AM. |
||
![]() |
![]() |
![]() |
Bookmarks |
|
|