Go Back   Rotary Car Club > Vendors and Group Buys > All Vendors > BNR Turbos

BNR Turbos www.bnrturbos.com (AL) Custom and rebuilt turbochargers

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 07-28-2008, 10:29 PM   #10
Bryan@BNR
Rotary Fanatic
 
Join Date: Feb 2008
Posts: 302
Rep Power: 18
Bryan@BNR is on a distinguished road
Quote:
Originally Posted by rotarycrazy View Post
you have stated a chiped ECU where can I get that done becouse rteck only does S4 turbo and NA S5 also someone told me that S5 ecu will not work by itself that it need to see the remainder of the wiring or it goes into limp mode is that true.
A stock ECU will work good. You will need to pull around 6 degrees out of the timing and then get some 720s with a Super AFC 2 along with a FCD. Then with all the other mods, you should be good for 12-13 psi of boost. I would definatly install an EGT gauge to monitor those exhaust temps, then you will see how much room you have to adjust your timing up or down with the crank angle sensor. Also just as crutial is your AFR's. Make damn sure to keep the engine running pig rich and don't run more than 11.4 AFR at full boost. You may be able to run more boost, but definately keep an eye on that tuning b/c you can ruin the engine in a second if you dont know what you are doing...
Bryan@BNR is offline   Reply With Quote
 

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:53 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com