Rx7 FC Adjustable Rear Toe Links

stuwk · 12-30-2014, 09:43 PM

Rx7 FC Rear Toe Links are now for sale! $175 + Shipping!

The Hex is adjustable with a 1" wrench, and the locking nuts are a
1 1/8th" wrench.

They are a direct fit and allow for standalone rear toe adjustment.

Pm me for info!

chibikougan · 12-31-2014, 02:05 PM

What is done to the tapered holes in the subframe and control arms?

Do they travel freely up and down?

Can you get a picture with the center propped up and let the control arms sag as far as they can?

stuwk · 12-31-2014, 03:35 PM

Oh man, I put this in all kinds of the wrong section.

Anyways the taper that you see on the stock links is simply a location finder because the stock toe link studs are significantly smaller than the actual hole. Only the first 3/8th" of the hole is tapered, the rest is a regular non tapered hole. The bolts used in these adjustable links fits and fills the regular non tapered part of the hole allowing for a tight fit and no movement. These has been used on several cars including an 8.8 swapped LS powered FC, which is the sub-frame in the picture.

I will see if I can get a picture like that but my set is back in a driving car.

chibikougan · 12-31-2014, 04:19 PM

The holes are tapered I had them machined for inserts. Yeah that's all I needed to hear thanks anyway.

12-30-2014, 09:43 PM	#1
stuwk The Newbie Join Date: May 2014 Posts: 14 Rep Power: 0	Rx7 FC Adjustable Rear Toe Links Rx7 FC Rear Toe Links are now for sale! $175 + Shipping! The Hex is adjustable with a 1" wrench, and the locking nuts are a 1 1/8th" wrench. They are a direct fit and allow for standalone rear toe adjustment. Pm me for info!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

12-31-2014, 03:35 PM	#3
stuwk The Newbie Join Date: May 2014 Posts: 14 Rep Power: 0	Oh man, I put this in all kinds of the wrong section. Anyways the taper that you see on the stock links is simply a location finder because the stock toe link studs are significantly smaller than the actual hole. Only the first 3/8th" of the hole is tapered, the rest is a regular non tapered hole. The bolts used in these adjustable links fits and fills the regular non tapered part of the hole allowing for a tight fit and no movement. These has been used on several cars including an 8.8 swapped LS powered FC, which is the sub-frame in the picture. I will see if I can get a picture like that but my set is back in a driving car.