Looking for PFC base map for ID 1000/2000

RICE RACING · 05-31-2014, 04:17 PM

you need to stop listening to random shitcunts.

define the problem and find its cause:

Is the crank signal dropping out dur FFE shit set up? scope this
If ok is the fueling correct for your ported motor? v's the stock calibration?
This is not that hard.

You will just waste time with another ECU, and a pfc does not run 1000cc inj well anyway. I do have a map I can send you but it will have mollested primary lag time so itca work @idle due to the pfc min injector limit restrictions.

05-31-2014, 04:17 PM	#3
RICE RACING Don Mega Join Date: Dec 2008 Location: Utopia Posts: 1,688 Rep Power: 18	you need to stop listening to random shitcunts. define the problem and find its cause: Is the crank signal dropping out dur FFE shit set up? scope this If ok is the fueling correct for your ported motor? v's the stock calibration? This is not that hard. You will just waste time with another ECU, and a pfc does not run 1000cc inj well anyway. I do have a map I can send you but it will have mollested primary lag time so itca work @idle due to the pfc min injector limit restrictions. __________________ www.riceracing.com.au Worlds best Apex Seals Coil on Plug Water Injection ECU Calibration

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode