Fuel inlets for IDA Weber

sen2two · 02-06-2014, 11:40 AM

I have a 3.2 glass ball needle valve from Jaycee.

Ok, The main reason I ask is because all of the Jaycee Webers I have seen use the top inlet as a feed source and the side port is plugged. I also noticed the top port is larger than the side port. But both are larger than the -6 line so I was unsure if that mattered. I was also was unsure if removing some of the turbulance had any effect on the needle valve regulating fuel as well....

I might be over thinking here though. My blow through set up isn't that wild.

02-06-2014, 11:40 AM	#4
sen2two KTEC Join Date: Jan 2009 Posts: 642 Rep Power: 0	I have a 3.2 glass ball needle valve from Jaycee. Ok, The main reason I ask is because all of the Jaycee Webers I have seen use the top inlet as a feed source and the side port is plugged. I also noticed the top port is larger than the side port. But both are larger than the -6 line so I was unsure if that mattered. I was also was unsure if removing some of the turbulance had any effect on the needle valve regulating fuel as well.... I might be over thinking here though. My blow through set up isn't that wild. __________________ what I have: 1985 Gs:12a All motor Drag car - 1973 Rx2: Play car What I had: 93 Touring: TRADED - 91 Coupe: TRADED - 90 GTU: RHD - 88 10AE: SOLD - 87 Base: SOLD - 86 Base: SOLD - 1985 GSLSE - 85 Gsl: SOLD - 80 Gs: TRADED - 1972 Rx2

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode