|
|||||||
| RX-7 1st Gen Specific (1979-85) RX-7 1979-85 Discussion including performance modifications and technical support sections |
|
|
Thread Tools | Display Modes |
|
|||||||
| RX-7 1st Gen Specific (1979-85) RX-7 1979-85 Discussion including performance modifications and technical support sections |
|
|
Thread Tools | Display Modes |
05-03-2013, 09:59 AM
|
#3 |
|
member
Join Date: Jun 2008
Location: Lebanon,Ohio
Posts: 282
Rep Power: 18  |
when I switched to an fc coil,I put 2 different connectors on the power wires so it can only be hooked up one way. I'll check the wires on the inside of the dizzy. I changed it out the last time it happened and I put the original dizzy back in and haven't had any problems out of it. I've been through the wire diagram in the fsm numerous times thinking I may have missed something. I'm not the greatest on those diagrams,I know the blk/y stipe is the + comi g from the ecu to the main relay to the dizzy to the coil. the y/blu stripe is - (for the leading) from igniter to coil. could the dizzy's ground be bad,but the trailing is firing fine? I'm baffled.
__________________
leaving my carbon footprint....one start up at a time |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode