Quote:
Originally Posted by RETed
Is that a groove (black line) in the counterweight???
I have NEVER seen a groove worn into the metal like that in my life.
Did you get an explanation for the groove?
That might wreck the rear oil seal?
|
Not so much a groove, it's shiny from wear...if you run your finger over it you can barely feel it. I do not know the history on it other than it came out of a 90. It's an eBay purchase, so I may not get a response to questions.
Since concerns have been raised, it was also painted, which I planned on lightly sanding off, but it has a small notch in it also. Is that small ding enough to cause balance issues?
I assume that taking it to a machine shop would then affect clearance between seal and counterweight?
__________________
Quote:
|
Originally Posted by yzf-r1
Take your pathetic ultimatums and stupid "AOL" comments and shove them straight up your ass, you little punk. You avatar is gay as well....
|
1990 Vert/ S5-JDM 13BT (rebuilt but with issues I'm working out). Rtek N370 1.7, 550/800 injectors, FD fuel pump, RB REV TII exhaust, Tein springs and Illuminas
03-01-2013, 07:06 AM
Threaded Mode