|
|||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
|
|
Thread Tools | Display Modes |
|
|||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
|
|
Thread Tools | Display Modes |
02-22-2010, 07:03 PM
|
#1 |
|
KTEC
Join Date: Jan 2009
Posts: 642
Rep Power: 0  |
rebuilding a motor, something strange?
I noticed there was slight scar on the rotor housing near the exhaust port. but there was nothing broken in the motor. So as i inspected the rotors, they looked fine also. until i checked the apex seal slot. the tops of them have burrs on almost every edge. I know this isnt normal, cause i havnt noticed this before in other builds i have done.
so would filing the burr off ever so slighty be ok? what might have caused this?
__________________
what I have: 1985 Gs:12a All motor Drag car - 1973 Rx2: Play car What I had: 93 Touring: TRADED - 91 Coupe: TRADED - 90 GTU: RHD - 88 10AE: SOLD - 87 Base: SOLD - 86 Base: SOLD - 1985 GSLSE - 85 Gsl: SOLD - 80 Gs: TRADED - 1972 Rx2 |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode