Can i use a low/high-imp injector combination?

Justen · 10-05-2009, 04:23 PM

My mistake, they are 550 purples.

I don't think i will put the low imp injectors in untill i get a standalone anyway, because i hear 1600s will most likely dump to much fuel into the motor when they actaully kick on, especially with the higher fuel press of a Walbro.

...But this lag in the injector cycle that you mentioned, wouldnt it be compensated for when i have the standalone tuned?

If worse comes to worse i could try to find low imp primaries and solder in resistors for all four injector leads.

Suggestions?

10-05-2009, 04:23 PM	#9
Justen In Too Deep Join Date: Jun 2009 Location: Clifton, NJ Posts: 112 Rep Power: 17	My mistake, they are 550 purples. I don't think i will put the low imp injectors in untill i get a standalone anyway, because i hear 1600s will most likely dump to much fuel into the motor when they actaully kick on, especially with the higher fuel press of a Walbro. ...But this lag in the injector cycle that you mentioned, wouldnt it be compensated for when i have the standalone tuned? If worse comes to worse i could try to find low imp primaries and solder in resistors for all four injector leads. Suggestions?