Quote:
Originally Posted by classicauto
Yea I saw that one of the slots was quite a bit wider..don't recall if you said it was the front or rear though. IIRC the rear was fine, but front haad one out of spec?
I guess my pic viewing micrometer needs a recalibration haha.....but yeah as long as your measurements show they're in spec, you're rockin!  |
Ha, I actually measured them bro. Front rotor slots all measured between 2.01-2.04mm. The bad rear rotor had one side with 2.03-2.05 BUT the other side of the rotor measured 2.15-2.18.
No good in my opinion. However, I can not find specs on the wear limits. ONly specs when Apex seal is installed via FSM.
06-26-2009, 03:04 PM
Threaded Mode