|
|||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
|
|
Thread Tools | Display Modes |
|
|||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
|
|
Thread Tools | Display Modes |
11-09-2009, 08:16 PM
|
#19 |
|
The quest for more torque
Join Date: Sep 2008
Location: Sheboygan, Wisconsin
Posts: 855
Rep Power: 17  |
Ok, maybe I am missing something, but what makes the P-port expensive?
All you need is a set of housings, some aluminum-ceramic or Devcon and a hole-saw. Then you can fill your side ports with iron-ceramic or Devcon and you have a P-Port. I doubt that you would need a 2-piece Eccentric shaft, etc. for a 250 WHp build.
__________________
1986 GXL ('87 4-port NA - Haltech E8, LS2 Coils. Defined Autoworks Headers, Dual 2.5" Exhaust (Dual Superflow, dBX mufflers) 1991 Coupe (KYB AGX Shocks, Eibach lowering springs, RB exhaust, Stock and Automatic) |
|
|
| Bookmarks |
|
|
Threaded Mode